Openport2.0 pin 11

User topics relating to hardware that interfaces PCs to ECUs

Moderator: Freon

Openport2.0 pin 11

Postby salt36 » Sat Dec 31, 2011 10:51 pm

OK a brief description, 2009 AUDM Mitsubishi Triton 3.5L 6G74 V6, ECU: M32r Renasis processor, 32176F4 Family.

I would like to know if it possible for the init code to run direct to pin 11.

I can read/flash my ECU on the bench using the Mitsu init plug running to pin 83 I think from memory on the ECU, this pin runs to pin 11 on the OBD.

Is there a way I can configure this ?

I would also like to be able to reverse this if the occasion demanded......
salt36
 
Posts: 10
Joined: Sat Apr 02, 2011 3:20 am
Location: Victoria Australia

Re: Openport2.0 pin 11

Postby salt36 » Fri Jan 06, 2012 1:47 am

I sorted it 8)
salt36
 
Posts: 10
Joined: Sat Apr 02, 2011 3:20 am
Location: Victoria Australia

Re: Openport2.0 pin 11

Postby radsdau » Sun Jan 08, 2012 4:28 pm

Good to hear. Care to share your solution with us?
:)
radsdau
 
Posts: 674
Joined: Wed Feb 08, 2006 6:56 pm

Re: Openport2.0 pin 11

Postby salt36 » Tue Feb 28, 2012 2:18 am

Whoops havent logged on for ages...... :oops:

I am going to use (whenever it arrives :roll: ) an OBD extension cable and splice the init wire into the pin 11 on the vehicle side of the extension cable.

I am hoping this will work and wont have to remove the ECU each time I want to flash..........
salt36
 
Posts: 10
Joined: Sat Apr 02, 2011 3:20 am
Location: Victoria Australia


Return to Interface Hardware

Who is online

Users browsing this forum: No registered users and 12 guests

cron