Subaru STI 2 - ECU connection
Posted: Thu Sep 30, 2010 11:46 am
Hi. I would like to connect a Subaru STI ECU out of the car. I have hooked up using this pattern:
E2, E3, E10, A14 to 12v
E15, B17 to gnd.
A5 to gnd is the green test connector
A20 to OBD pen 9 is the L-Line
A21 to OBD pen 7 is the K-line
A10 to OBD pen 11 is the flash voltage.
Connector A=B134, B=B136, E=B137
And this is what I obtain in ecuflash:
[18:02:43.149] Device Firmware Version: 1.07.2597
[18:02:44.287] kernel get version
[18:02:44.646] SSM2 init
[18:02:44.808] SSM2 ECU ID is 2E 44 59 61 05
Anyone can help me to get this ecu work out of the car?
I have some dubts on A20 and A8 connections, which are che pin that I have to bridge on the car.
Thanks to all.
E2, E3, E10, A14 to 12v
E15, B17 to gnd.
A5 to gnd is the green test connector
A20 to OBD pen 9 is the L-Line
A21 to OBD pen 7 is the K-line
A10 to OBD pen 11 is the flash voltage.
Connector A=B134, B=B136, E=B137
And this is what I obtain in ecuflash:
[18:02:43.149] Device Firmware Version: 1.07.2597
[18:02:44.287] kernel get version
[18:02:44.646] SSM2 init
[18:02:44.808] SSM2 ECU ID is 2E 44 59 61 05
Anyone can help me to get this ecu work out of the car?
I have some dubts on A20 and A8 connections, which are che pin that I have to bridge on the car.
Thanks to all.