2.0 cable usb not seen

User topics relating to hardware that interfaces PCs to ECUs

Moderator: Freon

2.0 cable usb not seen

Postby msgofast » Tue Nov 18, 2008 9:35 pm

I have the new can cable, and down loaded the 2.0 software, plug the usb into the PC and it doesn't see it, installing the software and says drivers were installed, but even if they weren't it would ask for a prompt, it doesn't see it at all.

is there something i am not doing?

cheers
michael
msgofast
 
Posts: 17
Joined: Thu Nov 30, 2006 12:55 pm
Location: Aust

Postby msgofast » Wed Nov 19, 2008 11:18 pm

Ok, when people first plug the openport 2 cable, does it promt you for drivers? or does it know it is plugged in?
msgofast
 
Posts: 17
Joined: Thu Nov 30, 2006 12:55 pm
Location: Aust

Postby radsdau » Thu Nov 20, 2008 3:42 pm

It definitely should detect the new hardware the first time and install the drivers.
radsdau
 
Posts: 674
Joined: Wed Feb 08, 2006 6:56 pm

Postby msgofast » Thu Nov 20, 2008 10:54 pm

I tried another usb cable, one off my phone, now it sees it drivers installed and lights come on, but plug into the car and i get a black window saying it can't do this operation?
msgofast
 
Posts: 17
Joined: Thu Nov 30, 2006 12:55 pm
Location: Aust

Postby AlGontsov » Tue Dec 02, 2008 5:06 am

After the proper installation of EcuFlash v1.40 OP2 should be visible.
AlGontsov
 
Posts: 35
Joined: Sun May 18, 2008 5:47 am

Postby msgofast » Tue Dec 02, 2008 11:10 am

I used an older software than the later one on the web and now it works.
msgofast
 
Posts: 17
Joined: Thu Nov 30, 2006 12:55 pm
Location: Aust


Return to Interface Hardware

Who is online

Users browsing this forum: No registered users and 7 guests