Anyone know how to Flash a SH7052 using the AUD Port?
Posted: Fri May 04, 2007 10:27 amI know most of you use OBD to interface with your ECUs but I noticed that some of the vehicles here use the SH7052 CPU and I was wondering if anyone here had any experience using the CPUs Advanced Users Debugging (AUD) port to flash the chip.
The ECU in question is from a Kawasaki ER-6n and like most motorcycles has no OBD port. It does however run all the AUD port lines to a connector on the edge of the board.
Any info on someone who manufactures an AUD - PC interface or software would be helpful. Of course I've already checked out the Hitachi/Renesas site. I was just hoping to fine something that wouldn't run into the thousands of dollars.
The ECU in question is from a Kawasaki ER-6n and like most motorcycles has no OBD port. It does however run all the AUD port lines to a connector on the edge of the board.
Any info on someone who manufactures an AUD - PC interface or software would be helpful. Of course I've already checked out the Hitachi/Renesas site. I was just hoping to fine something that wouldn't run into the thousands of dollars.