Anyone know how to Flash a SH7052 using the AUD Port?

User topics relating to hardware that interfaces PCs to ECUs

Moderator: Freon

Anyone know how to Flash a SH7052 using the AUD Port?

Postby RidgeRacer » Fri May 04, 2007 10:27 am

I know most of you use OBD to interface with your ECUs but I noticed that some of the vehicles here use the SH7052 CPU and I was wondering if anyone here had any experience using the CPUs Advanced Users Debugging (AUD) port to flash the chip.

The ECU in question is from a Kawasaki ER-6n and like most motorcycles has no OBD port. It does however run all the AUD port lines to a connector on the edge of the board.

Any info on someone who manufactures an AUD - PC interface or software would be helpful. Of course I've already checked out the Hitachi/Renesas site. I was just hoping to fine something that wouldn't run into the thousands of dollars.
RidgeRacer
 
Posts: 6
Joined: Sat Dec 02, 2006 1:09 pm
Location: Pacific Northwest

Return to Interface Hardware

Who is online

Users browsing this forum: No registered users and 7 guests

cron