Hey,
Is it one of the goals of the ecu software being developed here to read and clear CELs? Besides monitoring engine data, that would be a nice thing to be able to do.
Thanks,
Walter
Reading/Clearing CELs
Moderator: Freon
4 posts
• Page 1 of 1
Reading/Clearing CELs
by dubya_rx » Thu Jun 16, 2005 7:45 pm
- dubya_rx
- Posts: 18
- Joined: Thu Jun 16, 2005 7:43 pm
by calvinc » Sun Jun 19, 2005 9:53 pm
when you reset the ecu the CEL's are cleared and all learnt data is also cleared. don't think there is an app on here that currently does it but i can add it to the DL1 app - www.tari.co.za
it'll be in the next release (v1.0.41)
calvin.
it'll be in the next release (v1.0.41)
calvin.
- calvinc
- Posts: 163
- Joined: Sun Apr 24, 2005 10:18 am
- Location: south africa
by NeverLies » Thu Aug 04, 2005 2:57 am
Never heard of some free software to do this right now...
You may check also for generic EOBD software as CEL clearing is not something specific to SSM protocol. You may also do it with a software supporting EOBD (Subaru is using ISO9141/14230 on EOBD), just look for one.
You may check also for generic EOBD software as CEL clearing is not something specific to SSM protocol. You may also do it with a software supporting EOBD (Subaru is using ISO9141/14230 on EOBD), just look for one.
- NeverLies
- Posts: 179
- Joined: Tue Apr 12, 2005 1:49 am
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 45 guests