My RS2 is the one Mutt is talking about above...
GTODesign wrote:E5/6 does have the second init connector but the E4 doesn't.
E5/6 uses a different MCu to E7/8 which may explain why you are having problems with your OBDII loggers.
GTO I'm afraid that neither the E6 GSR or E6 RS2 (my model) have the second re-flash socket.
I posted the following in another thread. I hope you can help...
I am trying to initialize my Evo 6 RS2 ECU with the Tactrix OpenPort 1.3M cable.
I read this in another thread. Not sure if it also applies to my problem...
cboles wrote:...The new Mitsubishi cable needs and uses these drivers, (sic~ FT2DXX drivers/DLL) but since
there is no other software which works with that cable yet, there are no legacy support issues.
Unlike the Evo 7-9 models, the Evo 6 RS2 has
no additional socket alongside the
OBDII port under the dashboard.
I'm looking for an
alternative connector or wire that can be used on the
1999-2000 Evo 6 RS2s
(with Immobilizer) for initialization to reflash the ECU.
I know that the Evo 6 software is still a work-in-progress... but this seems
to be more of a hardware issue that will have to be addressed anyway.
At the moment any attempt to initialize results in this error message...
"H8/500 processors are not yet supported!"
Any help or advice appreciated.