Bad µSD slot on OP2.0 RevE?
Posted: Sat Nov 26, 2011 2:53 pm
Searched high and low for the proper home for this post found nothing.
Do the following characteristics constitute normal behavior for an OP2.0 RevE running FW 1.11.3137?
-OpenPort 2.0 device only intermittently shows up as a USB-connected device on the 32-bit Win7 PC to which it is connected.
-Known-good SanDisk 2GB FAT16 or FAT32 µSD card is almost always unrecognized when inserted into the µSD slot.
-When known-good SanDisk 2GB FAT16 or FAT32 µSD card is recognized, any extant files, e.g., logcfg.txt have been erased.
-When known-good SanDisk 2GB FAT16 or FAT32 µSD card is recognized often the file system has become unrecognizable, the volume is seen as RAW and in need of formatting.
-When known-good SanDisk 2GB FAT16 or FAT32 µSD card is recognized that recognition does not survive a reboot.
So each time I manage to get the µSD volume recognized, I have to copy over the logcfg.txt anew. Is there any point in trying to log since the files and/or FS will be erased the next time I plug the OP2.0 into the PC with the µSD inserted into the OP2.0, or is this how this product is supposed to work?
Do the following characteristics constitute normal behavior for an OP2.0 RevE running FW 1.11.3137?
-OpenPort 2.0 device only intermittently shows up as a USB-connected device on the 32-bit Win7 PC to which it is connected.
-Known-good SanDisk 2GB FAT16 or FAT32 µSD card is almost always unrecognized when inserted into the µSD slot.
-When known-good SanDisk 2GB FAT16 or FAT32 µSD card is recognized, any extant files, e.g., logcfg.txt have been erased.
-When known-good SanDisk 2GB FAT16 or FAT32 µSD card is recognized often the file system has become unrecognizable, the volume is seen as RAW and in need of formatting.
-When known-good SanDisk 2GB FAT16 or FAT32 µSD card is recognized that recognition does not survive a reboot.
So each time I manage to get the µSD volume recognized, I have to copy over the logcfg.txt anew. Is there any point in trying to log since the files and/or FS will be erased the next time I plug the OP2.0 into the PC with the µSD inserted into the OP2.0, or is this how this product is supposed to work?