Page 1 of 1

Hyundai Genesis Coupe - reflashing needed!

PostPosted: Mon Apr 27, 2009 9:01 pm
by jdgrimm
Hey forum members and the powers that be, the new Genesis Coupe(2.0 turbo) has been taking off like crazy over the last few months and is in dire need of reflashing software. I believe the ECU in this car is similar to the Mitsu ECU so maybe it would be possible to use the current software for Mitsu as a building block for the Genesis Coupe?

I think it would be an awesome step in the opensource world if the very first reflashing capability for a brand new vehicle was open source!!

Justin
GrimmSpeed

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Tue Apr 28, 2009 12:55 am
by Bluerb240
Don't some BMW's run the Siemens ecu? maybe that's the route to go. Traffic is slow here.

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Wed Apr 29, 2009 8:25 pm
by soondin
Hyundai Genesis 2.0T used Siemens ECU.

It have totally different process read/write.

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Wed Oct 07, 2009 9:00 am
by freshda9
So is there any active development on this?

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Thu Oct 08, 2009 1:18 am
by christian_piasini
freshda9 wrote:So is there any active development on this?


If you need to tune this car, have already few device can do it.
of course are not open surce.

www.cmdtec.it : CMD Flasher

Best regards


CHristian Piasini
R&D Piasiniengineering

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Sat Oct 10, 2009 6:33 am
by kiaracer
The nearest match I see is on this website : http://www.seoulfulracing.com

The name of the person is Jay, who does ECU tuning for Beta & V6. The ECU to be sent to them, with special instructions if needed be, and returned with the same ECU with parameters remapped. Email him at cs@seoulfulracing.com. He is very prompt in answering :shock:

Search the website with keyword "ECU", and all the turbo kits, complete with ECU will be displayed :D :D

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Sat Oct 10, 2009 10:21 am
by todd-w
not the ideal solution

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Sun Oct 11, 2009 7:20 am
by kiaracer
Apparently people are looking for a reprogramming interface with interactive software. I have the link below that will go straight to the device, but not sure if it will do 2.0T. The choices appear to be 2.0 N/A VVT, 2.5, 2.7. Also, there were previous discussions that the device will do only Korean domestic ECU's, but not USDM. However, www.seoulfuracing.com able to flash any ECU from all over the world. Any chance all ECU's are equivalent ?


Link to the eVOS VIM
http://yahocar.com/bemarket/shop/index. ... C+uid+desc

NGM house of power has a device that will flash, but no interface software (dumb device). That is why I mentioned "nearest match" :wink:

Re: Hyundai Genesis Coupe - reflashing needed!

PostPosted: Mon Oct 12, 2009 7:01 pm
by freshda9
christian_piasini wrote:
freshda9 wrote:So is there any active development on this?


If you need to tune this car, have already few device can do it.
of course are not open surce.

http://www.cmdtec.it : CMD Flasher

Best regards


CHristian Piasini
R&D Piasiniengineering



I dont need to tune one right now. but since i have already used ECU Flash and am familiar with it somewhat was hoping there would be some active development as i see this car will be a big hit in say 2-3 years when the used car market gets involved.