openecu.org

by **gordon1** » Fri Jan 30, 2009 7:34 am

hi i have a 2007 subaru new shap
want to read the ecu
can any help

by **radsdau** » Sun Feb 01, 2009 5:38 pm

Use OpenPort2 cable with Subaru CAN hookup method.

by **gordon1** » Tue Feb 17, 2009 2:02 am

hi there thanks for your reply but i did try the CAN but did not work , is the a way to do this ?
thank you

by **radsdau** » Tue Feb 17, 2009 2:57 pm

It is possible the 05DBW method is used for these, but I would have thought CAN was more likely. Give the other Subaru hookup methods a go.

If it's not CAN, you will need to connect the green test mode connectors. There may be more than one set; make sure the fans cycle when the ignition is turned on after connected the test mode connectors.

If that doesn't work, sight the ECU and perhaps even post a photo of outside and inside.

by **gordon1** » Sat Feb 21, 2009 10:28 am

i have done many 2004-5 but this is the new shap and cannot find the green / black plug ?

by **radsdau** » Sun Feb 22, 2009 3:18 pm

Odd. If it's the new shape it should be CAN. The CAN ones I've seen haven't required the green connectors to be connected.

by **gordon1** » Mon Mar 02, 2009 4:01 am

do you think i have the right lead ?

as when i tryed it on can it closed the program down ?

openecu.org

2007 subaru jdm sti new shap

2007 subaru jdm sti new shap

Re: 2007 subaru jdm sti new shap

Re: 2007 subaru jdm sti new shap

Re: 2007 subaru jdm sti new shap

Re: 2007 subaru jdm sti new shap

Re: 2007 subaru jdm sti new shap

Re: 2007 subaru jdm sti new shap

Who is online